Before you begin cleaning:
Invert box of HOST® Dry Carpet Cleaner for 10 minutes (this is all of the mixing you need to do).
If you are cleaning wool, Berber, natural fibers such as sisal, coir or jute, or delicate rugs such as Oriental, Chinese, or Persian, read “Cleaning Tips for Special Carpets & Rugs.”
There is no need to move major pieces of furniture.

vacuum
Step 1
Thoroughly vacuum all areas you plan to clean. Vacuuming helps remove dry soil from the carpet and makes cleaning easier.
Start with an empty vacuum cleaner bag.
Vacuum slowly and thoroughly. Pay special attention to high traffic areas such as entrances, hallways and in front of favorite furniture.
apply pre-spray
Step 2
If there are high traffic areas, tough spots or greasy, oily dirt within the 10′ x 10′ area of carpet, pre-spray with Pre-Clean.
Hold bottle waist-high and lightly mist Pre-Clean, using only 4 pumps per 3′ x 3′ area (do not use more than this; more is not better).
Allow Pre-Clean to sit on carpet for 2 – 3 minutes.
apply hostopen box of host
Step 3
Turn box upright and snip open the foil bag.
Apply about 9 handfuls of HOST to the 10′ x 10′ area of carpet.
Apply more on spots and spills and in high traffic areas (entranceways, hallways, in front of favorite furniture) and less in areas where people don’t walk.
Avoid applying to areas where there is no soil such as along walls or in corners.
Remember, only apply HOST to one 10′ x 10′ area at a time so the cleaning ingredients remain active.
CAUTION: Persons with unusual skin sensitivity should protect hands and arms from direct contact. Persons having respiratory ailments should avoid using in unventilated, confined areas.

squeeze lever remove tray
Step 4
Unwrap cord and plug machine into wall outlet (110 volt).
Place one foot on the edge of the tray. With hand near the base of the handle, lift the machine up and out of the tray.
Move the handle lock, found at the base of the handle, to the “Unlock” position.
To operate, squeeze the lever underneath the top of the handle. To lock the machine in the “on” position, slide the button on the top of the handle over while squeezing the lever.
CAUTION: Test the HOST Dry-Clean Machine in an inconspicuous area of the carpet. Some soft texture carpets may fuzz when brushed. If texture distortion occurs, do not use.

brush HOST through carpet
Step 5
Brush HOST through carpet
For maximum cleaning results, make 3 passes over the 10′ x10′ area with the HOST Dry-Clean Machine to thoroughly clean all sides of the carpet fibers.
brush diagram

Start in one corner of the 10′ x 10′ area and move sideways across the area using push /pull strokes to create an overlapping “W” pattern.

At the end of the row, step back to start a second row. Move sideways back across the area, overlapping about half of the first row. Continue brushing the entire 10′ x 10′
area this way.
Turn 90° to face across the area. Using the same technique as in the 1st pass, brush the 10′ x 10′ area completely.
Turn 90° again back to the first position and brush the 10′ x 10′ area completely a third time.
Tip: Occasionally tap the hood of the machine with your foot to release any HOST which may have gathered under it.

Tip: Heavily soiled traffic areas and tough spots may require some extra care. Apply more HOST to these areas and brush again. The more brushing you do, the better the results will be. With the HOST Dry Carpet Cleaning System, you don’t have to worry about overwetting the carpet.
vacuum
Step 6
Wait about an hour, then vacuum
Wait until HOST is completely dry (about an hour) and then simply vacuum.
HOST will lighten to a pale gold color as it dries.
Since HOST is all natural and safe for people and pets, you can use your room while it’s drying.
After vacuuming, a trace of HOST may remain in the carpet. This cleaner will not harm your carpet and will be removed with subsequent vacuuming.
If you notice a lot of HOST remaining, check your vacuum cleaner bag. Change the bag if it’s more than 1/2 full and vacuum again.
After cleaning, if you have HOST left over, close foil bag tightly to maintain freshness and store in a cool, dry place.

cleaning stairs remove handle
Stair Cleaning is Easy
Vacuum stairs before cleaning.
Remove the long handle from the HOST Dry-Clean Machine by lifting the small lever at the base of the handle and pulling
the handle up and out.
Start at the top of the stairs and work down.
If stairs are extremely dirty, mist each with HOST Pre-Clean first.
Apply one handful of HOST per stair.
To operate the machine, squeeze the lever underneath the lower handle and guide the machine across the stairs.
Make 3 passes as described in Step 5 “Brush HOST Through the Carpet.”
Wait until HOST is completely dry (about an hour) and then simply vacuum